KD-NX5000 HDD Navigation/DVD Receiver Instructions
Hard Disk Drive (HDD) Installation
This unit has a built-in HDD, which is a device to read minute magnetic changes. The inside of the device is precision components, requiring you to notice the following when installing the unit:
Install the unit at a place where the following conditions are satisfied:
• Dry and neither too hot nor too cold— between 5°C and 35°C. If the temperature is too low, the HDD will not work. Wait until the temperature in thecar becomes normal before operating the unit.
• At an altitude between –300 m below sea level and +3000 m above sea level.
• With adequate ventilation to prevent internal heat buildup in the unit.
Before using HDD
While the unit is turned on, the hard disk is constantly rotating at a high speed. This requires you to notice the following:
• DO NOT impart vibration or shock.
• DO NOT allow anything having strong magnetism or emitting strong electromagnetic waves (mobile phones, etc.) near the unit.
• DO NOT disconnect the power cords from the car battery when the unit is turned on. Failure in following the above cautions may damage the HDD (the stored data will be lost and be never restored)
Calibration
Before using the Navigation System first time, it is required to calibrate the Navigation System.
• After deleting the calibration data (☞ [46] Reset Calibration) or changing the installation angle (☞ [46] Installation Angle), calibration is also required.
1. Display the map screen.
2. Display the detail screen and check the connections.
GPS Antenna
• OK ] Connection is OK. ([5]: number of the GPS satellites whose signal is detected.)
• NG ] Aerial is disconnected or short-circuited.
Speed Signal
Drive the car for a while.
• If the number increases as you speed up the car, connection is OK. Parking Brake Step on the brake pedal, then disengage and engage the parking brake repeatedly.
• If Off appears when disengaged and On appears when engaged, connection is OK. If the result is not good, check the connection.
• You can see detailed information on the items of Sensor Status in Information.
3. After confirming all the above connections, drive the car to start calibration.
• This process can take five minutes or more depending on the average speed driven.
• A certain speed (greater than 40 km/h) is required for calibration.
• Calibration time differs among the cars.
• During calibrating, you can use the AV functions of the unit (you can listen to the music, etc.)
• If you turn off the ignition switch, calibration is temporarily stopped. When it is turned on, calibration will restart. Once calibration is finished, the arrowhead icon turns red and the current position information
appears instead of Calibrating…. Learning Lv. (maximum level is 4) reaches 1 after calibration finished.
Navigation (functions such as guidance or route simulation) cannot be used until calibration is complete.
Get pdf KD-NX5000 HDD Navigation/DVD Receiver Instructions
