Specialty Tigertop Installation Instructions
Install Front and Rear Aluminum Angles
Using the bolts from the factory hard top or those supplied in the kit, install the aluminum angle rails in the existing holes on the top of the body edge. Fasten the bolts with the 5/16″ Nuts and 5/16″ Washers from the parts kit. There should be a 3″ space between the two pieces on each side for the Bow Mounting Bracket. There will be an extra hole at either end of the rails. Drill a 3/16″ hole in the body at these locations and use the #14 x 1/2″ Sheet Metal Screws to secure the rails in place.
Install Bow Mounting Brackets
Locate one of the Bow Mounting Brackets and place it in the space between the side railings. The outside edge of the Bracket should be flush with the railing. Mark the two outside holes.
Center punch your marks and drill 5/32″ holes at these locations. Tighten the bracket in place using 2 #10 Sheet Metal Screws.
IMPORTANT: The Bracket secures to the vehicle by using two Sheet Metal Screws. Use the two holes in each bracket which are closest to the outer edge of the body.
Install Front Bow.
Connect the two halves of the Front Bow Assembly with a Bow Coupler and slide a short Bow Cover over each leg of the Bow. THE TWO LARGE HOLES IN THE FRONT BOW ASSEMBLY SHOULD FACE THE FRONT OF THE VEHICLE.
Mount one leg of the Front Bow Assembly into the front of the Bow Mounting Bracket, using the Clevis Pin and Hairpin Keeper. Repeat this process for the other leg of the Front Bow Assembly.
Get pdf Specialty Tigertop Installation Instructions
