Honda GXV340 GXV390 Owners Manual Guide
This manual contains information on how to do that; please read it carefully before operating the engine. If a problem should arise, or if you have any questions about your engine, consult an authorized Honda servicing dealer. INTRODUCTION Safety Messages Damage Prevention Messages Safety Information COMPONENT & CONTROL LOCATION Throttle Cable Connection LPG Connection Battery Connection BEFORE OPERATION CHECKS Is Your Engine Ready To Go OPERATION Safe Operating Precautions Starting the Engine Setting Engine Speed Stopping the Engine SERVICING YOUR ENGINE The Importance of Maintenance Maintenance Safety Safety Precautions Maintenance Schedule Refueling Fuel Recommendations Engine Oil Air Cleaner Spark Plug Spark Arrester
HELPFUL TIPS & SUGGESTIONS Storing Your Engine Adding A Gasoline Stabilizer To Extend Fuel Storage Life Draing The Fuel Tank And Carburetor Transporting TAKING CARE OF UNEXPECTED PROBLEMS TECHNICAL & CONSUMER INFORMATION Technical Information Serial Number Location High Altitude Operation Oxygenated Fuels Emission Control System Information Air Index Specifications Tuneup Specifications Consumer Information Honda Publications Wiring Diagram Distributor’s Limited Warranty Emission Control System Warranty Distributor/Dealer Locator Information Customer Service Information THROTTLE CABLE CONNECTION The throttle lever is provided with holes for attaching a solid wire throttle cable. 1. Remove the 5 mm screw and the cable holder. Hook the solid wire cable end into the throttle lever as shown. 2. Move the throttle cable control (located on equipment) into the FAST (or HIGH) throttle position. 3. Move the throttle lever by pulling the throttle cable until the throttle lever just contacts the choke arm. Install the cable holder securing the throttle cable and tighten it securely. 4. Move the throttle control (located on equipment) to move the throttle lever to the CHOKE position. Verify the engine choke rod moves the carburetor choke fully closed. Adjust the adjusting screw until it just contacts the choke arm. 5. Start the engine and move the throttle lever to the FAST (or HIGH) position. Using a tachometer, check the engine speed. Loosen the cable holder bolt and move the throttle cable to obtain the top no load engine speed specified by the equipment manufacturer.
Get Honda GXV340 GXV390 Owners Manual Guide
