DYNA III Electronic Ignition Installation Instructions
The Dyna III Electronic Ignition System has been designed for easy installation and does not require the use of special tools. The compact electronic module operates efficiently and was designed to clamp to a frame tube. It can be located anywhere that there is sufficient space, and does not require special considerations as it is completely vibration and water proof. The recommended location is on the left frame tube under the fuel tank. The DYNA III System was designed for use with stock coils. however. it may be used with other coils that have at least THREE OHMS primary resistance.
PROCEDURE
1. Fasten the clamp to the electronic module using the 4-40 x 5/16 screws and locknuts pnovided. The clamp and nuts go on the inside of the case.
2. Remove the fuel tank. Attach the module to the frame in the location selected. Cut off excess clamp material.
3. Remove an engine case or valve cover bolt and fasten the ground lug (black wire) securely to the engine. DO NOT ATTACH TO FRAME.
4. Locate the two ignition coils (they are positioned behind the left side cover an some models). There is a white wire going to the positive side of one coil that carries the switched 12 volts. A short blue/black wire then connects that point to the positive side of the other coil. Connect the separate red wire included with the kit to the spare spade terminal that is available on the positive terminal of the second coil.
5. Plug the red wire coming from the electronic module into the red wire installed in Step 4.
6. Remove the cap from the contact breaker housing. Remove the alternator cover, timing mark inspection plug, and spark plugs.
7. Remove the two screws and clips holding the points plate to the housing. Remove the screws holding the condensers to the housing. Disconnect the red and green wires where they plug into the wire harness (or coils), and remove the entire points/plate/condenser assembly.
Get pdf DYNA III Electronic Ignition Installation Instructions
