Model 1260 Wheel Balancer Manual
The machine can operate on any flat non resilient floor.Make sure that the machine rests solely on the three support points provided (Fig.2a). It is advisable to secure the system to the ground using the specific feet (Fig. 2a). if the machine is continually used with wheels weighing over 35 kg. The machine is supplied with a single-phase mains cable plus earth (ground). The power supply voltage (and mains frequency) is indicated on the machine identification plate and cannot be changed. Connection to the mains must always be made by expert personnel. The machine must not be set up without proper earthing.
Connection to the mains should be through a slow acting safety switch rated at 3 A (230V) or 8 A(115 V).
Adapter mounting
Controls and components
Manual distance measurement gauge
This gauge serves to manually measure the distance between the point of application of the counterweight and the machine. The wheel balancer is supplied complete with cone adapters for fixing wheels with a central hole. Other optional adapters can be mounted:
a) Remove the threaded end-piece A after unscrewing the screw B.
b) Mount the new flange (see attached sheets).
Note: CAREFULLY CLEAN THE COUPLING SURFACES BEFORE PERFORMING ANY OPERATION.
Wheel guard assembly and adjustment (optional)
a) Fasten the components to the base as illustrated in specific exploded view.
b) With the guard closed check that the microswitch prod has slipped into place on the ring.
c) Appropriately adjust the angular position of the control ring.
N.B.: Do not lean on the guard during the wheel balancing cycle.
Get pdf Model 1260 Wheel Balancer Manual
