2006 Chevrolet Corolado/GMC Canyon L4-2.8L AirCharger Installation Instructions
TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Depress the locking clip on the mass air sensor electrical connection, and then separate the mass air sensor electrical connection.
3. Loosen the hose clamp that retains the stock intake tube to the resonator, and then remove the tube from the resonator as shown.
4. Loosen the two air box retaining bolts and one retaining nut.
5. Lift up the air box and remove it from the vehicle.
6. On vehicles equipped with a fuel pressure regulator disconnect the fuel pressure regulator vacuum hose from the fuel pressure regulator as shown.
7. Loosen the two bolts that retain the intake resonator to the engine, and then loosen the hose clamp at the throttle body.
8. Remove the intake resonator from the engine as shown.
NOTE: Disconnect the crankcase vent hose from the valve cover while removing the resonator from the engine.
9. Install the silicone hose (08690) onto the throttle body and secure with the provided hose clamp as shown.
10. Install the “L” bracket (010060) onto the heat shield with the provided hardware as shown.
11. Install the edge trim onto the heat shield as shown.
NOTE: Start the 26″ edge trim at the heat shield mounting bracket on the bottom of the heat shield. Some trimming may be necessary.
12. Install the edge trim onto the inner hole on the heat shield as shown. Trim if needed.
13. Install the “L” bracket (070602) onto the stock air box-mounting stud using the factory air box-retaining nut.
Get pdf 2006 Chevrolet Corolado/GMC Canyon L4-2.8L AirCharger Installation Instructions
