BBR Rear Disk Brake Kit Instructions
Thank you for the purchase of this rear disc brake kit for the CRF/XR50! Everything is included in this kit to add a rear disc brake to your BBR Perimeter Aluminum Frame kit based motorcycle. If you are adapting this kit to the OEM Honda frame or another aftermarket frame kit, you will need our adapter kit PN 550-HXR-5050. Because installation of this kit is beyond the control of BBR Motorsports, Inc, we cannot accept responsibilty for misuse or improper installation. This kit is intended only for use on off-road motorcycles. These instructions are intended only as a supliment to the proper Honda service manual. If the installation of this product is beyond your technical abilities please refer to qualified service personel.
1. Support bike on stand with rear tire off of ground. Remove seat and body work. Remove rear wheel and brake pedal.
2. Remove shipping bracket from master cylinder.
3. Remove shipping wedge from the caliper.
4. Install master cylinder on frame using supplied 6mm bolts.
5. Install master cylinder reservoir on upper subframe bolt using the supplied bracket and longer bolt.
6. Slide caliper (on mount) onto back of swingarm
7. Stick brake hose mounts onto swingarm. Be sure to clean the swingarm to insure that they stick properly.
8. Install rotor and sprocket on the rear hub. BBR recommends using a thread lock adhesive on all these bolts
9. Install rear wheel. Use care to insure that the rotor slides between the brake pads and the wheel spacers stay in place.
10. Install brake pedal tip in desired location. BBR recommends using a thread lock here also.
11. Unsnap the clevis pin from the bottom of the brake reservoir.
12. Install the brake pedal spring on the top bolt mount.
13. Install the brake pedal and hook the bottom end of the brake pedal spring on the pedal.
14. Adjust the clevis to line up with the brake pedal.
Get pdf BBR Rear Disk Brake Kit Instructions
