Honda VFR750 Scottoiler Installation Guide
Locate the vacuum – There is a rubber bung over a spigot on the inlet side of the front carburetor, as shown below left. Remove this bung and then press the Damper Elbow, part number 4, onto the spigot. The RMV can be positioned under the seat, as shown in the third picture. The more vertical the RMV the better and remember to avoid exhaust and engine components. For further information, see our easy step installation guide – ‘RMV Positions, General’.
The Dispenser Assembly, shown bottom left, is routed along the Swingarm and secured to the spindle using a Dispenser Plate, part numbers 19 & 20.
Alternatively, The Dispenser Assembly is mounted to the swinging arm using the Dispenser Mounting Plates (parts 19 & 27) coupled together using a Single Sided Swingarm Adapter, available Free of Charge from Scottoiler, as shown below.
The nib of the dispenser should feed the sprocket between the 6 & 7 o’clock positions on the sprocket, the cut face facing outwards.
Once fitted, fill and prime the system and set the adjuster knob to ‘prime’.
Start the engine and turn the adjuster knob until a flow of between 1 and 2 drops per minute is achieved.
Check the condition of your chain after a ride, and then adjust as required.
Get pdf Honda VFR750 Scottoiler Installation Guide
