2008+ Mitsubishi Lancer QuickLIFT Installation Guide
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas springs (RT-QL-170-A6A) - Be sure to cycle them a few times before installing.
* (4) #2-3/16″ Multi-grip rivets (used on hood brackets)
* (2) ball-studs and washers each with a locking nut.
* (2) mounting brackets
* Printed Color Instructions
* Gas Spring locking clips - (Already installed in the gas spring ball-ends - Remove before assembly)
Please gather the following tools before you begin the installation:
* Power Drill
* 3/16″, indexed #11 & 5/16″ drill bits
* Fine permanent marker or felt tip pen
* Tape measure or ruler
* Masking tape
* Hammer & center punch
* Rivet gun,capable of 3/16″ rivets (most brands can handle this size)
Note: Only use the rivets supplied in the QuickLIFT system.
Get pdf 2008+ Mitsubishi Lancer QuickLIFT Installation Guide
