WXT510 WMT50 Wiring Diagram pdf
To avoid exceeding the maximum ratings in any condition, the voltages must be checked with no load at the power supply output.
Electrical Connections
Wiring Using the Screw Terminals
WARNING Make sure that you connect only de-energized wires.
1. Loosen the three long screws at the bottom of the WXT510/WMT50.
2. Pull out the WXT510/WMT50 bottom part.
3. Insert the power supply wires and signal wires through the cable gland(s) in the bottom part.
4. Connect the wires according to Table1.
5. Replace the bottom part and tighten the three screws.
Wiring Using the 8-pin M12 Connector
External Wiring
If the WXT510/WMT50 is provided with an optional 8-pin M12 connector, the connector is located on the bottom of the transmitter. The pins of the 8-pin M12 connector as seen from outside the transmitter are illustrated in the following figure.
Get pdf WXT510 WMT50 Wiring Diagram pdf
