NeoChanger Instruction Manual
Installation Preparation (All Vehicles) Anti-Vibration Setup Load/Unload Magazine CHAPTER Dip-Switch Overview (REQUIRED) Acura Audi Ford (Ford, Lincoln, Mercury) GM (Buick, Cadillac, Chevy, GMC, Oldsmobile, Pontiac, Saturn) Chrysler (Jeep, Dodge, Plymouth, Eagle) Honda Toyota Volkswagen CHAPTER Troubleshooting Warranty/Warnings FCC and Legal Information Installation Preparation This chapter provides information required for the installation of the Neo Changer, it must be read by all users. Thank you for purchasing the Neo Changer. Since the Neo Changer will works in many different vehicles the following steps must be taken to ensure the changer is set up correctly for the vehicle it is being installed in.
Before Installation To prevent damage to your vehicle and the changer take the following precautions. 1. Turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the vehicle is equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the battery cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution to avoid causing a short circuit during installation. If your radio has a security code make sure you know the code and how to enter it prior to removing the battery cable.
Get pdf NeoChanger Instruction Manual
