RS900ERII/RS901II Series II Remote Engine Starting System Installation Instructions
PROGRAM/OVERRIDE SWITCH: 2 PIN PLUG
This switch is used primarily for programming features of the RS900/901. However, if the Anti-Grind/Starter disable feature is installed, you MUST INSTALL this switch. This switch will allow the user to override the starter disable in the event of a non-operating remote control.
LED: 2 PIN PLUG
The LED is only used as a VALET/PROGRAMMING indicator. The LED comes on solid when the unit is in valet or programming mode. The LED is not a mandatory installation item.
12 PIN PLUG:
PIN 1: YELLOW: (-) IGNITION 1 OUTPUT (FOR RELAY)
PIN 2: YELLOW/WHITE: (-) IGN2/ACC OUTPUT (FOR RELAY)
Use these wires when the vehicle requires a second IGNITION 1, IGNITION 2, or ACCESSORY wire to be activated. This occurs commonly in Toyota, and late model GM cars.
PIN 3: BLACK: MAIN SYSTEM GROUND
Connect to chassis metal of the vehicle. An existing bolt or screw MAY provide an adequate ground, or drill a small hole, scrape away paint and attach using a sheet metal screw & star washer. If this wire is not connected OR connected to a point on the vehicle that provides a poor ground, undesirable and inconsistent operation will occur.
PIN 4: YELLOW/BLACK: (-) ANTI-GRIND/STARTER KILL OUTPUT
Use this wire for the negative side of the Anti-Grind/Starter Disable relay. It can also be used for the sensor disable circuit for a host alarm for RS901. This output activates whenever a remote start is requested, and when the vehicle is remotely locked with the transmitter.
Get pdf RS900ERII/RS901II Series II Remote Engine Starting System Installation Instructions
