SF 500-HP Installation and Operating Instructions
The SuperFlush™ permanently mounted flushing system back-flushes your entire engine while the engine is off. You must flush your engine after each use to prevent the damaging effects of saltwater corrosion. To use the SuperFlush System, simply connect a dockside water source to the hose connection access panel provided in the kit and installed on your boat. The flushing operation takes four minutes to fully clean your entire engine water system.
Use of Chemicals with the SuperFlush™ System
SuperFlush offers as the following chemicals as, approved materials for use with the system :
1. FLUSHCLEAR
2. RUSTGUARD
3. Any approved auto antifreeze
Only SuperFlush approved materials are warranted for use with this system.
PRECAUTIONS!
1) SuperFlush should only be installed on the recommended engine system that it is designed for.
2) If your engine has mufflers in a through transom exhaust system, make sure that during the flush cycle, the water can free flow out of the engine.
3) Flush the engine for approximately four minutes.
4) Disconnect the dockside water source from the SuperFlush system before leaving the boat.
5) When flushing the engine with the boat in the water, make sure that conditions are calm (less than one and a half feet of chop).
6) Never run the engines while the SuperFlush system is in use.
Get pdf SF 500-HP Installation and Operating Instructions
