42-48 Ford Car Installation Instructions
Remove all parts from you dash, except Speedo trim ring. Install ( 10 ) 8/32 x 5/8 studs in dash adapter as shown in Photo #1.
Install ( 2 ) Gauges in dash adapter as shown in Photo #2.
Install dash adapter as shown in Photo #3
From rear of dash.
Using ( 2 ) 10/32 x 3/8 Pan Head Screws & Washers.
Install the 2 outside gauges as shown in photo #4 & #5.
Do Not Over Tighten Gauges to Panel. Overtightening may break the glass. Leave Clear Protective Covering On Your Panel Until It Is Com- pletely Installed, To Protect The Highly Polished Surface.
This is what it will look like before gauge trim ring is installed. If your dash still has the studs on the rear of the gauge trim ring they will have to be removed. Use doubled sided tape, or silicone to re-install trim ring. Install ( 4 ) 8/32 x 5/8 studs in adapter. Use brackets supplied to install Speedo or Tach adapter in dash from the rear. The 2 holes closest to outside edge of adapter is for the brackets. In some cases these brackets will have to be bent slightly. Now install Speedo or Tach as shown.
Get pdf 42-48 Ford Car Installation Instructions
