2010 Hyundai Genesis Coupe L4-2.0L Turbo AEM Dryflow Filter Installation Instructions
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Jack up the front of the vehicle and support using properly rated jack stands.
f. Do not discard stock components after removal of the factory system.
2. Removal of stock system
a. Remove four clips securing the air scoop and remove scoop.
b. Loosen the hose clamp on the inlet hose and unclip four clips on the air box top. Remove the air box top.
c. Remove three M6 bolts securing the air box bottom and remove the air box bottom.
d. Loosen the hose clamp at the compressor inlet and slide the two squeeze clamps back on the breather hoses at the valve cover.
e. Remove one M6 bolt securing the washer filler neck, and unplug the right front headlight.
f. Lift the car and remove the right front wheel. From underneath the vehicle, remove three clips and one screw from the inner wheel well liner. Pull the wheel well liner back out of the way.
g. Unplug the washer pump and washer fluid level sensor.
h. Remove two M6 bolts securing the washer bottle. Unplug the hose from the washer pump and remove the washer bottle from the car. Drain any remaining washer fluid into a clean container so it can be reused. Set the washer bottle aside.
Installation of AEMо intake system.
When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so.
a. Install the compressor inlet coupler as shown with a #56, and a #44 hose clamp. Plug in the headlight that was unplugged in step 2e.
b. Install the M6 rubber mount as shown.
c. Install the inlet pipe by lowering the front end into position, then inserting the rear end into the compressor inlet coupler. Then guide the bracket into position on the rubber mount, and secure it with one M6 nut and washer. Leave the M6 nut loose for now.
d. Install the larger diameter breather hose supplied using the stock spring clamps. Install the smaller diameter breather hose using the two small clamps supplied in the kit.
Get pdf 2010 Hyundai Genesis Coupe L4-2.0L Turbo AEM Dryflow Filter Installation Instructions
