Jeep Liberty 2″ Coil Spring Lift Spacer Installation Instructions
Get ready to install front coil spring lifts.
1. Under the hood driver side.
a. Remove bolt (4), battery hold down (5), and battery (3) from battery tray (6) and vehicle. b. Remove two bolts (7), nipple (8), and battery tray (6) from inner fender (9). Do not disconnect battery tray from wiring harness (10).
c. Remove vent line (11) from nut (12).
2. Under the hood passenger side.
a. Remove four clips (13), clamp (14), and air box cover (15) from air duct (16) and air box (17).
b. Remove air filter (18) from air box (17) and vehicle.
c. Remove three nipples (8) and air box (17) from inner fender (9) and vehicle
3. Lift front of vehicle.
a. Loosen five lug nuts (19) each from two front wheels (20).
b. Using a hydraulic jack, slowly lift front of vehicle so that two front tires (21) are three to five inches off of ground. Position two jack stands under body (22) in the factory recommended lifting positions. Lower body onto jack stands. Remove hydraulic jack from vehicle chassis.
c. Remove five lug nuts (19) each and two front wheels (20) from axle (23).
4. Remove front axle passenger side hardware.
a. Position hydraulic jack under lower A-arm (24) and apply pressure. Do not lift.
b. Remove nut (25), bolt (26), and bolt keeper (27) from strut fork (28) and lower A-arm (24).
c. Remove bolt (29) and strut fork (28) from strut assembly (30).
