Gobi Hummer Sut Rack Installation Instructions
The rack must be inspected before each use to make certain attachments are secure, and for evidence of Wear. Misuse of the rackor failure to observe the manufacit/rer ’s mär action s as to installation, proper Attachment and maintenance will void any warranties that may be implied by law.
1. Plastic Bag labeled #1 remove contents and press rubber protective strip #1 on to bottom of fairing #2.
2. Plastic Bag, labeled #2 re move c ontents and place black button head sere w #3 thru blac k washe r and then thru fairing #2. Place fairing onto bracket #4 and attach black washer, lock washer and wing nut finger tight only. Attach all 4brackets but do not attach fairing to rack at this time.
3. If the GOBI roof rack calls for 2″ support brackets bom the front and rear factory cross bars must be removed at this time. If the GOBI roof rack calls for 4″ brackets remove only the rear cross bar and slide the front cross bar #14 back approximately 36″ from the front of the roof track #15 as shown in Fig. 1 page 4 do not fully tighten down cross bar at mis time.
4. Plastic Bag labeled #3 remove contents and insert black “T” nuts #6 into roof tract sbt 6a to bom roof tracks #15 and space apart as shown in Fig. 2 page 4.
5. Plastic Bag labeled #3 remove contents and place the rubber washer #7 on to factory roof track slot above each “T” nut both tracks.
6. Place support braeke t #8 in the di ree tio n shown in the illustrano n with small bolt ho les face d down onto rubber washer #7 and thread bolts, lock washers and washers #9 found in Plastic Bag, labeled #3 thru support bracket #8 and into “T” nut ff6. Make certain “T” nuts are installed in vehicle roof track óa correctly as shown in Fig. 3 page 4. Repeat mis step to all #8 support brackets and keep spacing of #8 support brackets as shown in Fig. 1 page 4. Finger tighten bolts at mis time.
7. After all #8 support brackets have been installed and spaced as shown in Fig. 1 page 4 place the GOBI reck #11 with welded-in brackets #1 la on top of all #8 support brackets.
8. After placing the GOBI rack #11 on top of the #8 support brackets slide the black rubber washers #10 found in Plastic Bag labeled #4 between all 6 GOBI rack welded-in brackets #11 a and the #8 support brackets. Install all #12 bolts, washers, lock washers and nuts found in Plastic Bag labeled #4 as shown in the illustration page 4 and fìnger tighten at mis time.
9. Align rack with vehicle and tighte n all nuts and bolts sec urei y. Co mpletely tighten factory rear cross bar at this time.
Get pdf Gobi Hummer Sut Rack Installation Instructions
