GB Fitting Instructions for Basic Carrier
First Time Installation
Remove parts from packaging and check contents. Contact your Prorack dealer if parts are missing or damaged.
This kit fits type A, B and C.
These instructions show type A crossbar fitted. They also apply to type B and C.
NOTE: Clamp images in these instructions may not be representative of the clamps in this kit
Use keys to remove covers.
Use hex screwdriver to reverse adjusting screw 10 turns.
Press adjusting screw and pull crossbar legs out. Refer to the crossbar instructions for crossbar adjustment. Ensure each end of the crossbar is adjusted equally ‘X’.
Remove locking screw.
Cut protective strip in four equal lengths.
Apply protective strip as shown.
Trim if required.
Attach clamp to each leg. NOTE; clamps may have labels showing their positions on the vehicle (For example; “Front Right”)
Refit locking screw so that it goes through the hole in the clamp. Do not begin to tighten the locking screw.
Fit rubber pad (supplied with crossbar) to foot.
Make sure the pad fits into the holes underneath the foot.
Place crossbar on vehicle. Minimum recommended spacing between the bars is 700mm (unless otherwise stated).
Adjust the legs on the crossbar so that they are positioned equally from the ends of the crossbar, and the clamps engage firmly on the body work of the vehicle.
Tighten adjusting screw to 5 Nm.
Get pdf GB Fitting Instructions for Basic Carrier
