05-06 Jeep Grand Cherokee 2″ Spacer Kit
The factory service manual specifically states that striking the knuckle to loosen the ball joints or tie rod ends is prohibited. Striking the aluminum knuckle can damage it. A special puller tool #8677 (or equivalent ball joint tool) is recommended to be used to separate these components from the knuckle.
INSTALLATION INSTRUCTIONS
fRont InStAllAtIon
1. Park the vehicle on a clean, flat surface and block the rear wheels for safety.
2. Open the hood. Disconnect the negative battery cable.
3. On the driver’s side of the vehicle, pull the long narrow electrical box from of the plastic retaining clips to expose one of the three mounting nuts for the power distribution center. Remove the three nuts and pull the power distribution center up to access the top strut nuts. (Fig )
4. Remove the four driver’s side strut retaining nuts. Save nuts for installation. DO NOT remove the center stem nut, it is under extreme pressure.
5. On the passenger’s side, remove the coolant reservoir mounting hardware and move the reservoir to expose the passenger’s side strut nuts. Remove the four strut nuts and retaining. DO NOT remove the center stem nut, it is under extreme pressure. (Fig 2)
Get pdf 05-06 Jeep Grand Cherokee 2″ Spacer Kit
