1987-1995 Jeep YJ 4.5” Suspension System
This kit includes new braided stainless steel brake lines. Installation of these lines requires the entire brake system to be bled following the completed installation and prior to operating the vehicle. Consult your owner’s manual for the proper brake fluid to use for your vehicle. Fluid is not included in this kit.
fRont InStAllAtIon
1. Park the vehicle on a clean, flat surface and block the rear wheels for safety.
2. Disconnect the front track bar from the axle. Retain hardware.
3. Disconnect the rear track bar from the axle. Retain hardware.
4. Raise the front of the vehicle and support with jack stands under the frame rails just behind the front spring hangers.
5. Remove the wheels.
6. Disconnect the OE steering stabilizer from the axle and from the drag link. Retain the axle mounting bolt, discard the rest.
7. Disconnect the drag link from the pitman arm. Remove the cotter pin and nut. Free the tie rod end taper using a pickle fork. Retain nut.
8. Remove the nut and washer mounting the pitman arm to the steering box. Remove the pitman arm from the steering box using a pitman arm puller. Note the indexing of the pitman arm before removal.
Get pdf 1987-1995 Jeep YJ 4.5” Suspension System
