2006 Dodge 1500 ½ Ton 4wd 2″ Spacer Kit
Measure from the center of the wheel up to the bottom edge of the wheel opening
LF______ RF______ LR______ RR______2.
NOTE: The factory service manual specifically states that striking the knuckle to loosen the ball joints or tie rod ends is prohibited. Striking the aluminum knuckle can damage it. A special puller tool #8677 (or equivalent ball joint tool) is recommended to be used to separate these components from the knuckle.
INSTALLATION INSTRUCTIONS
1. Park the vehicle on a clean, flat surface and block the rear wheels for safety.
2. Raise the front of the vehicle and support with jack stands under the frame rails.
3. Remove the front wheels.
4. Disconnect the sway links from the sway bar (Fig 1). Retain the OE stem nut, washers and bushings. Complete the removal and installation on one side at a time, starting with the passenger’s side.
5. Remove the tie rod end nut at the knuckle and retain (Fig 2). Disconnect the tie rod end from the knuckle using the appropriate puller.
6. Remove the nuts from the three upper mounting studs holding the strut to the frame (Fig 3). DO NOT remove the center strut nut.
Get pdf 2006 Dodge 1500 ½ Ton 4wd 2″ Spacer Kit
