Hummer Winch – Operation Check
Winch Motor Operation
1. Set the Winch Clutch to “Free”. (Illustration 1)
• Refer to diagram on Winch (Illustrations 2 and 3).
2. Connect Winch Controller. (Illustrations 4 and 5)
• Remove protective cap on top of Winch and connect the Controller. (Illustration 6) Refer to Owners Manual.
• It may be necessary to partially lower the brush guard in order to connect the Winch Controller.
3. Secure Winch Spool.
• The Winch Spool should be secured using the Wood Block. Press and hold the Wood Block against the Line on the Spool to prevent the Spool from turning. This is done to prevent the cable from becoming loose on the Spool.
• DO NOT hold the Spool by hand. If the Winch Clutch is not fully disengaged, the Spool will turn and injury may result.
4. Activate Winch Motor.
• Briefly run Winch Motor in the “Spool Out” mode.
• Winch Motor should run, but Spool should not turn.
• If Spool turns, double check that the Winch Clutch is fully disengaged.
• If Spool does not turn, run the Winch Motor for several seconds in each direction.
• If Winch Motor will run in “Spool Out”, but not in “Spool In”, run in “Spool Out” for about 20 to 30 seconds and try again.
• If Winch Motor will not run in the Spool In direction, DO NOT unspool any cable – you will not be able to get it re-spooled.
Get pdf Hummer Winch – Operation Check
