Audi A4 Brake Installation Manual
PREPARATION FOR INSTALLATION
1. Be sure that the vehicle is parked on level concrete and the parking brake is on.
2. Place stops in front of and behind rear tires.
3. Consult owner’s manual for proper lifting and wheel removal procedures before lifting front of vehicle.
4. Place jack stands under vehicle for added stability.
5. Remove wheel.
6. Place a brake line clamp on the brake line. This will minimize brake fluid loss.
7. Using an 11mm wrench, disconnect brake line from caliper. Be aware that brake fluid may leak from line once disconnected.
8. Disconnect ABS sensor grommet from mounting bracket by pulling straight up.
9. Disconnect brake pad sensor from mounting bracket. Pry tab up gently with small flat head screwdriver, rotate counterclockwise 90 degrees, and lift up.
10. Clip the section of wire between the brake pad and the plug. Be sure to leave sufficient wire length coming from the plug in order to crimp the wires together. Strip 1/8” of the insulation on the wires and connect them together using a wire crimp as illustrated in picture bellow. It is recommended to protect the connection by applying shrink-wrap around the wire crimp.
11. Place the pad sensor plug in the small opening on the upright.
12. With a zip tie included in the kit, secure the plugs placement by zip tying it tightly to the ABS wire that is also running through the upright.
Get pdf Audi A4 Brake Installation Manual
