Audi TT & VW Mk 4 Front Installation Manual
These instructions are for the Audi TTand Volkswagen Mark IVchassis vehicles. The photos shown are of an Audi TT. The Volkswagen applications use the same caliper brackets, rotors and hats, and the caliper bodies are identical, so the installations are very similar on all vehicles. The one main difference is the brake lines, which may vary slightly from the photos shown. Also, brake pad wear sensors and ABS line routing may vary. Though the actual fitment may look slightly different, the order in which the kit is installed is the same for all vehicles.
This Kit Incudes the Following:
1 pair of ST-40 4-Piston Calipers
1 set of high performance brake pads (Not suitable for track use)
1 pair of 328mm X 28mm AeroRotors
1 pair of caliper adapter brackets, with stainless steel mounting studs and hardware pre-installed.
1 pair of stainless steel covered Teflon brake lines.
- 1 pair of “C” clips for brake line brackets (used for VW kits only)
- 1 pair of Banjo Bolts
- 2 pair of copper washers
- 1 pair of rubber end caps
- 2 High temperature Ty-Wraps
Caliper, Hat and Bracket Finish Disclaimer
Many wheel-cleaning solutions contain strong acids that may damage the finish on any caliper and or aluminum anodized finish, especially the plating on the hardware. Check for adverse effects by trying a small amount of the cleaner in question on an inconspicuous area. Avoid over spraying, and rinse the cleaning solution off as quickly as possible. STOPTECH will not be held liable for damage to caliper, hat or bracket finish due to corrosive chemical exposure.
A level, stable and clean surface suitable for supporting the car on jack-stands should be used for the installation.
Get pdf Audi TT & VW Mk 4 Front Installation Manual
