Chevrolet C6 Corvette Figure Grille Set Installation Manual
C6 Corvette Figure Grille Installation
1) INSTALL BUMPER GRILLE
1.1) Prepare grille. Feed the screwdriver through the hole indicated in Figure-1. Place a #6 washer on a #8 screw and then tape this combination to the Phillips head screwdriver. Scotch tape is the best type of tape to use, and make sure to secure the majority of the tape to the screwdriver shaft (See Figure-1). This will allow for you to easily remove the tape after the screw is installed in the bumper.
1.2) Position grille. Carefully insert the grille in the bumper opening taking care to not scratch the vehicle. When properly fit, the grille will sit against the OEM grille.
1.3) Install. Feed the screw/washer through the hole indicated in Figure 2 and screw until the screw has tapped through the bumper. Do not fully tighten the screw at this time, leave it about halfway secure.
1.4) Prepare left portion of grille. Carefully pull the left side of the grille from the bumper and load the screwdriver with a screw/washer as you did in step 1.1.
1.5) Finish. Carefully place the left side of the grille back against the OEM grille and then install the left screw/washer fully. Once the left is fully tightened, fully tighten the right grille.
Get pdf Chevrolet C6 Corvette Figure Grille Set Installation Manual
