Time-Based Progressive Nitrous Controller Installation Instructions
Your NOS Progressive Nitrous Oxide Injection Controller is designed to provide you with an ability to “adjust” the rate at which power from your nitrous oxide injection kit is applied to your vehicle. This controller is capable of operating any NOS nitrous system that features the nitrous and fuel solenoids with a maximum combined current draw of 40 amps, not including safety solenoids. Note that the highest current draw of any standard single stage NOS system is approximately 23-30 amps (NOS Pro Fogger P/N 02462NOS).
Initial power (solenoid duty cycle) is adjustable from 0-100%. The rate at which the solenoid duty cycle is increased (power increased) is adjustable from 0-10 seconds. Maximum power is adjusted through jetting changes, similar to a conventional nitrous oxide injection system.
The time-based progressive nitrous controller is applicable to a variety of vehicles using the NOS nitrous oxide injection kits. The basic controller and operating principle is the same for your vehicle regardless of whether it is carbureted or equipped with electronic fuel injection. However, the mounting hardware necessary for a safe installation varies with application. Listed below are the three types of nitrous oxide injection kits produced by NOS, and the application kits necessary for a proper installation.
Get pdf Time-Based Progressive Nitrous Controller Installation Instructions
