1996+ Ford MIL Eliminator Installation Instructions
1. Disconnect vehicle negative battery cable.
2. Remove rear O2 sensors and mark each so that they can be installed in the same location.
Note: O2 sensors forward of the catalytic converters will not be affected or removed.
3. Carefully cut the factory sheathing from the O2 sensor wires approximately 2 inches from the connector side to expose the wires.
Note: Nothing will be done to the two white wires.
4. Cut the O2 sensor black wire.
5. Splice the MIL Eliminator black wire to the O2 sensor black wire.
Note: Splice with solder and protect with heat shrink tube.
6. Splice the MIL Eliminator green wire to the O2 connector black wire.
Note: Splice with solder and protect with heat shrink tube.
7. Cut the O2 sensor gray wire.
8. Splice the MIL Eliminator gray wire (same side as black wire) to the O2 sensor gray wire.
Note: Splice with solder and protect with heat shrink tube.
9. Splice the MIL Eliminator gray wire (same side as green wire) to the O2 connector gray wire.
Note: Splice with solder and protect with heat shrink tube.
10.Wrap each splice with electrical tape.
11. Bundle up excess wire and wrap with electrical tape.
Get pdf 1996+ Ford MIL Eliminator Installation Instructions
