2005-2009 Ford Econoline w/Tow/Haul Mode BrakeMax BMC501-A Installation Instructions
HARNESS
1. Disconnect the battery negative cable.
2. Locate the OEM BLACK, 3-pin connector located below the steering column. (See Photo). Separate the connector and connect the BMC501 BLACK, 3-pin connector in-series with the OEM connector halves. Ensure that the connectors are fully seated.
3. Attach the BLACK wire to a known good ground point.
4. Position/secure the BMC501 Control Module under the dash near the steering column area.
5. Plug the BMC501 Harness Connector into the BMC501 Control Module.
FINAL STEPS AND INSPECTION PROCEDURE
6. Prior to replacing components, perform a functional test. Connect the battery negative cable.
7. Set the park brake and start the engine.
8. Verify that the “Tow/Haul” light illuminates on the shifter handle.
9. Finish routing of the BMC501 harness and retain as needed to protect the harness.
Get pdf 2005-2009 Ford Econoline w/Tow/Haul Mode BrakeMax BMC501-A Installation Instructions
