99-06 Chevy/GMC Silverado/Sierra 6.5 Bed GM-001 Armor Lid Installation Manual
This truck bed cover is designed for trucks that DO NOT have a bed liner. Trucks that DO have a bed liner may require some minor trimming or modification of the bed liner to insure proper placement for the brackets. Trimming or modification will vary between different brands of bed liners and model of your truck. Remember: Any modifications must be made to the bed liner and NOT to the installation hardware. Modifications to the installation hardware will result in a improper installation and will void your warranty. (See page 9 for do’s & don’ts regarding bed liners.
Step 1
Remove factory tail gate cap. Using a T30 bit.
Step 2
Install aftermarket tailgate cap to cover factory bolt holes
Step 3
Install front brackets using 4 M8X30 Bolts, 4 lock washers, 4 washers & 4 C clamps. If you have bed liner, this area may have to be notched or cut. (See page 9 for do’s & don’ts regarding bed liners)
Step 4
Install rear brackets using 4 M8X30 Bolts, 4 lock washers, 4 washers & 4 C clamps. If you have a bed liner, this area may have to be notched or cut. (See page 9 for do’s & don’ts regarding bed liners)
Step 5
Note: Make sure the front flap hangs over the bulkhead of the truck and is not rolled under the lid.
Make sure the tail gate is up & “Dry fit the lid.” Attach the lid to the front tabs & set it on the truck.
Get pdf 99-06 Chevy/GMC Silverado/Sierra 6.5 Bed Armor Lid Installation Manual
