FORD C-6 Aluminum Servo Kit Installation Instructions
1. Remove the old servo assembly and clean bore and gasket areas.
2. This servo kit will fit 19681⁄2 and later cases.
NOTE! Servo bore must be 3.493″ to 3.495″ with surface finish of less than R16. Early cases must be bored out to these specs for proper operation of this servo kit. In all cases, the servo should be checked for fit before final assembly. The servo must move smoothly in the outer inch of the case.
3. Install the spring into bore.
4. Generously apply TransJel™ to the servo bore in the case.
5. Insert the servo assembly into the case. Insert bolts and tighten.
6. Place the servo cover into position on the case. Insert bolts through the cover into the case and tighten.
Source pdf for FORD C-6 Aluminum Servo Kit Installation Instructions
