BMW D7 Workshop Manual
A four-stroke diesel engine with direct injection and open-circuit cooling system. The Neoprene impeller of the coolant pump is driven directly from the crankshaft. Electric starter and flywheel alternator are standard equipment. The injection system is fitted with automatic bleeding.
This workshop manual describes complete procedures for dismantling, overhaul and assembly of the BMW D7 marine engine. If only part of the procedure is to be carried out (e.g. small repairs or replacement of gaskets, oilseals) the remainder can be ignored. The relevant technical data is provided with each section. General specifications are found on page iii.
Assembly is generally a reversal of removal procedure. Special attention, however, should be paid to “notes on assembly”. Checking and adjustment procedures, where applicable, are to be found at the end of the relevant section.
Get pdf BMW D7 Workshop Manual
