1965-1972 Full-Size Ford DB1512M Installation Instructions
Installation of any component or kit should only be performed by persons experienced in the installation and proper operation of disc brake systems. It is also the responsibility of the person installing any brake component or kit to determine the suitability of the component or kit for that particular application.
NOTE: Before operating the vehicle after installation test the function of the brakes under controlled conditions. Make several stops in a safe area from low speed and gradually work up to nor- mal speeds. DO NOT DRIVE WITH UNTESTED BRAKES! Always utilize safety restraints when operating the vehicle.
STEP 1:
1. Check to be sure that your kit has all the necessary parts needed to complete this project! (Use the supplied parts list as a check list.)
STEP 2:
Remove the following components from you car:
Tech tip: Prior to disassembly spray the nuts and bolts that will be removed with a penetrant.
1. If you are performing the installation with a jack, be sure that the parking brake is set and that the rear wheels are chocked. Support the front of the vehicle with jack stands. Never work on sloping ground.
2. If you are using a lift, raise the vehicle to a comfortable working height.
3. Remove the front tires.
4. At this point, be sure to place the proper support under the lower control arm. Failure to do so will allow the coil spring to blow out when spindle is removed, which could result in vehicle damage and possible serious injury or even death.
5. Next, disconnect the drum brake hoses from the hard line using the appropriate flare wrenches.
6. Detach the steering arm from the tie rod.
7. Now disconnect the ball joints from the spindle and remove the drum brake assembly as a unit.
8. Clean and inspect ball joints and tie rod ends for excessive wear or damage, replace at this time if necessary, in preparation for assembly.
Get pdf 1965-1972 Full-Size Ford DB1512M Installation Instructions
