GMC Sierra/ Chevy Silverado, GMC/Chevy HD Cut Out Flare Installation Instructions
NOTE: Bushwacker only approves installing the flares according to these written instructions with the hardware provided.
WARNING: Failure to install according to these instructions will invalidate the warranty. This includes, but is not limited to using alternative installation methods, hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar products on the hardware or the flares.
Step 1: Painting (Optional)
It is recommended that painting be done prior to installation.
(A) Sand (optional) before application of paint.
(B) Clean outer surface with a good grade degreaser. DO NOT USE LACQUER THINNER OR ENAMEL REDUCER AS A DEGREASER. Wipe outer surface thoroughly with a tack rag prior to painting.
(C) Paint flares using a high quality lacquer, enamel, or polyurethane automotive paint. Application of a primer coat is optional.
(D) If painting edge trim (not recommended), use a flex additive.
Step 2: Preparing the Work Area (Front and Rear)
(A) Remove factory fender trim and mud flaps (when installed).
Step 3: Edge Trim Installation (See Illustration #1)
(A) Peel two to three inches of red vinyl backing away from edge trim tape. Applying the adhesive side of the edge trim to the inner side of the flare, affix the edge trim to the top edge of the flare (the portion that comes in contact with the side of the vehicle).
(B) Press edge trim into place along top edge of the flare in one-foot increments, pulling red vinyl backing free as you continue to work your way around the top edge of the flare.
Get pdf GMC Sierra/ Chevy Silverado, GMC/Chevy HD Cut Out Flare Installation Instructions
