TF-80/81SC, TF-60SN Lockup Clutch Control Valve Kit Instructions Datasheet
Adapter plate F-15741-TL29PL is required to hold VW 09G (TF-60SN) and Volvo/Opal (TF-80SC) valve body sections while reaming. Adapter plate is not required for Ford/Mazda (TF-81SC).
Note: Mounting instructions are included with the Adapter plate F-15741-TL29PL. Disassembly Steps
Remove the retainer, plunger sleeve with plunger valve, spring and lock-up valve. Keep the retainer for re-use and discard all other OE pieces.
Important Notes:
1. Clean the bore thoroughly in a solvent tank.
2. Generously lubricate the bore and reamer with cutting fluid (i.e. Mobilmet S-122, Lubegard Bio-Tap, Tap Magic™, etc). For best results, provide a continuous flow of water-soluble cutting fluid (i.e. Mobilmet S-122) during the reaming process.
3. The reamers should be turned using a low rpm, high torque air drill regulated to a maximum of 200 rpm.
4. Examine the bore after cleaning for surface finish, debris, and burrs. Flashing and burrs on the exit side of lands and bores must be carefully removed. A small piece of Scotchbrite™ material attached to a wire and powered with a drill motor is ideal for the task.
Get pdf TF-80/81SC, TF-60SN Lockup Clutch Control Valve Kit Instructions Datasheet
