1/5 FM-1e DUCATI 999R R/C EP MOTORBIKE
INSTALLING THE ELECTRIC MOTOR AND ELECTRIC SPEED CONTROLLER
a. Remove the bike’s front suspension by disassembling the “E” clips on the steering shaft.
b. Remove the shaft that holds the front steering mount and front fork shocks.
c. Lift the entire set and remove it from the motorbike’s assembly.
d. Tighten the motor pinion with hexagon screw
e. Install the motor mount and motor unit onto the side chassis by treading two internal hexagon screws through the washers and motor mount.
f. Use a thin sheet of paper and insert it between both gears to set proper gear mesh.
g. Tape the E.S.C. to the top of the battery tray by using the supplied double-sided tape.
h. Install the E.S.C. switch onto the left side of the chassis frame by using a piece of appropriated double-sided tape
i. Solder the E.S.C. black/red wire to the terminals on the motor. (Note: The red wire to the positive terminal, black wire to the negative terminal)
j. Reassemble the front suspension assembly
INSTALLING THE RADIO GEAR
a. Mount the steering servo on the servo tray. (Note that its output shaft should be centered between the chassis frames.)
b. Install the receiver on the receiver tray by using double-sided tape.
c. Thread the receiver antenna/wire through the antenna tube, and then press-fit the antenna tube on the receiver tray
d. Properly plug the connection/wire into the receiver: steering servo connector/wire into the channel 1 slot, BEC power connector/wire into channel 2 slot.
e. The assembly diagram for the entire radio control system is shown.
Get pdf 1/5 FM-1e DUCATI 999R R/C EP MOTORBIKE
