Sniper X1 Vehicle Security System Installation Manual
With the alarm disarmed, switch the ignition ON. Within 10 seconds press the valet switch 6 times, after 2 seconds, the siren will chirp for 2 seconds and then the system enters into the code learning mode. Within another 10 seconds, press any button of the first transmitter, the siren will chirp for 1 seconds and lights flash twice to confirm the code has been learned. Apply the same procedure within next 10 seconds for the second transmitter. The system will leave the code learning mode after finishing learning the code for 2 transmitters. If two transmitters are not programmed, the ignition is switched OFF or the time exceeds the 10-second programming time, the system will leave the code learning mode.
Programming Features
Enter programming mode:
1. With the drivers door OPEN, turn the ignition ON then OFF
2. Press valet switch 3 times
3. Wait for siren to sound extended chirp to confirm system is in programming mode
4. Press the valet switch the same number of times as the option number you want to program, waiting for the corresponding number of chirps after each press. eg. to program “Channel 3 Output” press the button 6 times as it is option 6 in the programming table
5. To program this option as described in Column 2 (default) of the table of programming features turn the ignition ON and wait for 2 seconds until siren sounds an extended chirp. To program as described in Column 2 turn the ignition ON then OFF and wait for 2 seconds until siren sounds an extended chirp.
6. The system has now left programming mode, to program another feature repeat steps 1 to 5
Get pdf Sniper X1 Vehicle Security System Installation Manual
