Stratmosphere HyperBoost Valve Installation instructions
What’s included with your package:
• One HyperBoost diverter valve
• Two medium sized hose clamps
• One small hose clamp
• One instruction sheet (you are reading it)
Tools required for your installation:
• A medium sized flat-blade screwdriver
• Tin snips
• Regular or needle nose pliers
• A bit of motor oil or vegetable oil
Notes about this document:
• Shown is the replacement of a valve in a 2001-2002 Audi TT 225hp model. Most of what is shown here is applicable to other 1.8T or single-turbo models. See the end of this document for Adjustable instructions.
Step 1- Remove motor cover (Audi TT)
Two tough tasks on this step. Let’s remove your cover if you have a TT (figure 1). Just twist the two screws 90 degrees counterclockwise. Then lift up the cover (figure 2). The cover slides onto two horizontal tabs in the back section of the motor.
Step 2- Remove hoses from OEM valve
The clamps for the top “nipple” and the large side nozzles are attached with single-use clamps usually (figure 3). You will have to use needle-nose or tin snips to remove the single-use clamps. Hopefully these images help you see what must be done. In figure 4 you can see where the OEM diverter valve is located.
Get pdf Stratmosphere HyperBoost Valve Installation instructions
