2007 Ducati 1098 Installation Instructions
1. Remove the seat and solo cover.
2. Remove the cover around the fuel tank (Fig. A).
3 Remove the fuel tank
4. Remove the inner fairing cover on the right hand side (Fig. B)
5. Lay the PCIII in the tail section temporarily.
6 Route the PCIII harness through the hole in the tail section (Fig. C)
7. Route the PCIII along the right hand side of the subframe . Secure the PCIII harness to the subframe using 2 of the large supplied zip ties (Fig. D)
8 Unplug the stock wiring harness from the rear injector (Fig. E) This injector is located on top of the air box. To remove the connector you must first remove the spring clip. This is best done with a pick or small screw-driver
9 Plug the YELLOW colored wires from the PCIII in-line of the stock wiring harness and rear injector (Fig. F). Make sure to reinstall the spring clip on the stock connector.
10 Use 1 of the small supplied zip ties to secure this connection to the fuel line. Make this connection as compact as possible.
11 Unplug the stock wiring harness from the front injector (Fig G). This connection is very difficult to access. It is best to get to thru the front of the bike directly above the radiator. Figure G was taken from the front of the bike inside the right hand fairing and above the radiator.
Get pdf 2007 Ducati 1098 Installation Instructions
