1937 Ford Cool LEDs Installation Instructions
1. Disconnect Battery. Do not skip this step. Also, do not try to “test” the LED array by connecting the leads directly to your battery. Permanent damage will occur to the LED array if you fail to heed these steps.
2. Remove taillight lens and bezel.
3. Remove light bulb and light bulb holder.
4. Remove the LED array from the stainless steel bracket.
5. Route the supplied electrical harness through the taillight and to the area where connections will be made.
6. Install the stainless steel bracket in the taillight housing using the supplied screw. Also attach the green ground wire from the supplied harness to this screw.
7. Attach the plastic connector on the supplied harness to the LED array.
8. Deform the supplied plastic spacers to hold them on the screw during installation.
9. Align the LED array and stainless steel bracket while installing the supplied stainless steel screws and lockwashers.
10.Reassemble the rest of the taillight.
11.Wiring. Using the supplied connectors, connect the wire from the taillight circuit to the black wire on the supplied harness. To use the connector:
12.Repeat by connecting the wire from the brake light circuit on your car to the red wire on the supplied harness. If your car is fiberglass, the housing must be grounded.
13.Repeat for the other side.
14.Reconnect the battery.
15.Test both STOP and taillight functions.
16.Enjoy!
Get pdf 1937 Ford Installation Instructions Cool LEDs
