2003-07 Ford Power-Stroke V8 6.0L
The 4” straight hose is pressed over the turbo inlet until its butted up against the inlet. Use two power bands to fasten the hose to the turbo inlet, tighten the clamp on the turbo inlet side for now. The 19mm hose is pressed over the 90 degree hard pipe (A) The 19mm hose is now installed (B).
The cast intake is lowered and aligned with the 4” hose over the turbo inlet. Once you have aligned the cast intake to the 4” hose, continue to insert the intake into the hose. Adjust the cast intake for best position but do not tighten the power band at this point.
Loop the 19mm hose over the radiator overflow tank and align it to the intake port. Use the small clamp in the kit to fasten the hose over the intake port. The clamp is now fastened over the 19mm hose as shown above.
Press the 5 1/2” hose over the end of the intake. Use two power bands and tighten the clamp over the cast intake for now.
Press the Injen/AMSOIL grommet into the the 3/4” pre-drilled hole located on the plenum. Note: The grommet has been designed to be rotated for proper clearance of the air restrictor gauge.
Get pdf 2003-07 Ford Power-Stroke V8 6.0L
