2005-2009 Ford Mustang A-Pillar Rattle Noise
Some 2005-2009 Mustang vehicles may exhibit a rattle noise where the A-pillar meets the dash area. This rattle may be due to worn, missing or off location tape under the dash panel and/or A-pillar dual lock (velcro) fastener(s) not seated.
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
1. Remove A-pillar trim.
2. Inspect for tape under flanged edge of dash panel. If tape is missing or damaged, then add or replace with improved tape. This tape has a plastic top coating to protect the felt tape from wear. Install felt tape with adhesive side down.
3. Attach tape to end of screwdriver. (Figure 3) Insert under dash panel flange with plastic side of tape up. (Figure 4) Press down on dash panel to secure adhesive. Hold pressure on dash while removing screwdriver.
4. Inspect both A-pillar trim and A-pillar sheet metal to make sure both dual lock (velcro) fasteners are present. Replace if missing
5. Install A-pillar. Press to securely mate dual lock fastener.
Get pdf 2005-2009 Ford Mustang A-Pillar Rattle Noise
