Remote Auto Start Installation Manual
This remote start product is intended for installation on vehicles equipped with automatic transmissions and electronic fuel injection only!
DO NOT INSTALL THIS UNIT INTO A MANUAL TRANSMISSION VEHICLE AS IT COULD RESULT IN SERIOUS INJURY OR DEATH.
• This product must be installed by qualified personnel according to these instructions and observing all safety features.
• The system should be placed into the valet mode when parked inside a garage or being left for service.
• Always notify service personnel that the vehicle is equipped with a Remote Starter.
• Only start the vehicle in a well ventilated area.
Do not use in a closed garage or indoors.
ITEMS INCLUDED:
• Main unit
• Remote transmitter(s)*
• Plug In LED
• Plug in program switch
• Harness kit with 2 heavy duty fuse holders
• Hood pinswitch
• Extended range receiver module*
• Owner’s manual
*S models are provided with single transmitter only.
Add-on modules do not include transmitters.
OPTIONAL ACCESSORIES:
•VAC-10 Vacuum Switch Kit
• APP-1 Universal OEM transponder bypass kit
• APV-1 GM VATS, Passlock I&II bypass kit
• PDLM-3 Power door lock relay module
Before you begin the installation:
• Verify that the vehicle is equipped with electronic fuel injection.
• Verify that the vehicle is equipped with an automatic transmission.
• Check to see if the vehicle is equipped with any type of factory security system.
• Check to see if there is a pinswitch for the hood, if not one must be installed.
• Verify that the vehicle starts and idles properly before you start the installation.
• Verify with the customer the desired location for the program switch and LED.
• Always use a multimeter when verifying vehicle wiring.
Remote Start Installation Notes:
The remote start unit senses the vehicle’s success- ful start using one of the following methods:
1. Current sense
2. Tachometer sense
3. Spark or coil wire sense
4. Using optional vacuum switch
Get pdf Remote Auto Start Installation Manual
