Ford 2″ Coil Spring Spacer Kit with Stud Extenders Installation Instructions
If your vehicle has factory 2 ½” studs holding the coil spring onto the axle assembly, you will not need to use the stud extensions.
Step:
1. Read complete instructions and check Bill of Materials before beginning.
2. Raise the front of the vehicle and support the frame so that the front tires just touch the ground and remove the front tires.
3. Remove the lower shock bolts and the sway bar end link attaching points.
4. Remove the upper and the lower coil spring clamp bolt and nut with washer. See figure 1 and 2.
5. Force the axle half down so that the coil spring comes loose.
6. Remove the coil spring and the coil spring rubber isolator. See figure 3.
7. Install the corresponding Stud Extensions (if needed) onto the coil spring lower clamp stud and install the coil spring spacer onto the coil spring pad. See figure 4.
8. Install the coil spring onto the coil spring spacer and then into the frame. You may have to use a coil spring compressor. See figure 5.
9. Install the upper and the lower coil spring clamp bolt and nut with washer. Make sure that the coil spring is seated correctly into the upper frame. See figure 6 and 7.
10. Reconnect the sway bar end link attaching points and the shock nuts.
11. Torque all bolts and nuts to factory specifications. Re-torque all bolts and nuts after 500 miles.
12. Install front tires and remove the jack stands. Lower the vehicle onto the ground.
13. It is recommended that you have a front-end alignment.
Get pdf Ford 2″ Coil Spring Spacer Kit with Stud Extenders Installation Instructions
