1999 Chevrolet Silverado Push Bar Assemblies Installation Instructions
STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Determine Driver and Passenger Uprights and Top and Bottom Tubes. (Uprights are positioned so raised side of bolt holes are facing each other and the Tube with the two pierced holes is the Bottom Tube).
STEP 4. Fasten Uprights to Top and Bottom Tubes using (4) ― - 13 x 1.50” Flathead Bolts, and (4) 3.00” OD Push Bar Gaskets. Level tubes and torque bolts to 60 ft. Lbs.
STEP 5. Fasten Light Mounts to Bottom Tube using (2) 3 3/16 x 1.00” Self-threading Bolt and (2) / Nylon Washers. Tighten and torque to 20 ft. lbs.
STEP 6. Remove plastic shroud above grille by removing the seven pin retainers. Pull center pin up with small flat screwdriver.
STEP 7. Remove grille from truck by removing 6mm bolt from top of grille. Turn the four retainers ΕΎ turn counter-clockwise with Phillips screwdriver. Pull on outer edge of grille by applying firm pressure away from the fender, repeat on the opposite side. Carefully remove grille from vehicle.
STEP 8. To install top brackets, remove both 12mm factory bumper bolts from top of frame (located behind the top side of bumper), and remove two 6mm bolts in radiator support frame (located just above On each side, replace with spacer tube, top mount bracket, stiffener bracket, ―” flat washer, ―” lock washer, and M12-1.75 x 90mm bolt, 12mm and 6mm bolts.
Get pdf 1999 Chevrolet Silverado Push Bar Assemblies Installation Instructions
