2005 Accord 4-Door Full Nose Mask Installation Instructions
INSTALLATION NOTE:
• Make sure the vehicle and the nose mask are clean and completely dry before installation. If moisture under the mask is allowed to dry, it may cloud the paint. If the mask gets wet, remove it and allow it to air-dry completely.
• Make sure any repainted surfaces are cured.
• Make sure the hood and nose of the vehicle have been waxed with a high-quality paste wax.
• Make sure you install the nose mask securely. If the nose mask starts to flap, or comes loose while driving, safely pull off the highway, stop the vehicle, and secure or remove the mask.
1. If your state law requires the display of both license plates, cut out the piece of the bumper section that covers the front license plate:
• Face the inside of the mask toward you.
• Using scissors, carefully cut out the license plate section at the top seam, and remove the overcast stitching
2. If the vehicle you are working on is equipped with fog lights, cut out the piece of the bumper section that covers the fog lights:
• Face the inside of the mask toward you.
• Using scissors, carefully cut out the fog lights section and remove the overcast stitching
Installing the Hood Section
3. Open the hood, and remove the two insulator clips. (Do not discard the insulator clips; they can be reinstalled if the mask is removed.)
4. Fit the corners of the hood section around the hood, and adjust the mask so it fits smoothly over the edges. Hook the two elastic straps into the holes in the hood.
Installing the Bumper Section
5. Turn the steering wheel all the way clockwise.
6. Pry out the plastic pin, and remove the expansion clip that fastens the inner fender; retain the pin and the clip, then clean the area around the hole.
Get pdf 2005 Accord 4-Door Full Nose Mask Installation Instructions
