Rocket Locker Side Rails Installation Instruction
Upon receipt of the Rocket Locker, the casting and the light should already be assembled and wires should be fed thru casting.
Step 1: Feed wires thru hole in the oval gasket.
Step 2: Install Allen head bolts through the hole in Rocket Locker casting, plastic oval gasket, and rubber expander.
Step 3: Install threaded back plate on Allen head bolt. Snugly tighten the back plate against the rubber expander.
Step 4: Remove the tail light lens. To do this, open tailgate and remove the screws that hold the lens in place (refer to picture below). If you are not sure which screws hold the lens in place refer to your owner’s manual on how to replace tail light bulbs. Then release the tabs on the other side of the lens.
Step 5: Set your tail light on a secure place such as the tailgate be careful not to pull too hard and rip the wires apart. The picture below shows the tail light lens removed from the body of the truck.
Step 6: Feed the wires of the Rocket Locker through an opening between the stake pocket hole and the tail light opening, if there is not an opening you may need to drill a hole.
Step 7: Install the Rocket Locker casting by inserting the back plate and rubber expander into the stake pocket hole until the black gasket sits on top of the truck bed. For trucks without stake pocket holes, you will need to drill a hole for the Allen Head bolt slightly larger than the diameter of the bolt and one for the wires, about ΕΎ” hole.
Step 8: Install the tube and other end casting. To do this, install one o-ring (tabs facing the open side) on the end of the Rocket Locker casting, slide the tube onto the Rocket Locker casting then install an o-ring onto the other casting. Slide the other end casting into the tube. Then follow Step 7 to secure the end casting on the truck box.
Step 9: Follow the diagram on the last page to correctly use the blue quick connects supplied with your Rocket Locker.
Get pdf Rocket Locker Side Rails Installation Instruction
