2007-08 Honda Fit M/T & A/T Base Injector Upgrade Kit
The KraftWerks Honda Fit Injector Upgrade kit is designed to be used in conjunction with the KraftWerks Fit Base Supercharger Systems. If you are a competent mechanic with a good set of tools, the installation will be relatively simple. This is a general installation guide for the KraftWerks Fit Injector Upgrade kit; however each installation may vary slightly. Please keep these key factors in mind before installing:
Please review the entire installation guide before attempting install. If you have any questions about your ability to perform this installation, we recommend you take your vehicle to a performance shop for installation.
For tools you will need:
- A full set of metric wrenches from 8mm to 19mm
- A full set of metric sockets from 8mm to 19mm
- A screwdriver set
- Tin Snips
All of the tools required for this installation can be purchased at a local hardware or auto parts store.
Make sure that your vehicle has premium gasoline in the tank (91 Octane or more). Run several tanks of Premium fuel through your car prior to installing the supercharger to ensure that there is good Premium grade fuel throughout the system. If you are using a discount brand of fuel, we suggest you switch to a “top tier” gasoline. It is a good practice to get into.
Always wear safety glasses when working on your vehicle.
Do not smoke during this entire installation.
Work in a well-ventilated area. You will be working around gasoline and gasoline fumes
SECTION 1: PRE-INSTALLATION PRECAUTIONS:
Step 1: Remove the negative battery cable. Before removing the battery cable, verify that you have the “anti theft” radio code. It is usually located in your owner’s manual or on the side of the glove compartment. If you cannot find the radio code, take your car to your local Honda dealer so that they can retrieve the code through the Honda computer network.
SECTION 2: INJECTOR INSTALLATION
Step 2: Remove the plastic cosmetic cover from the intake manifold.
Step 3: Remove the five 12mm headed bolts/nuts that hold the plastic upper intake manifold to the aluminum lower manifold. Be careful when these two manifolds are not bolted together. Errant bolts/nuts or debris could fall into the intake manifold and cause severe engine damage. It is recommended that you cover the lower intake runners with protective tape or a shop towel.
Step 4: Remove the gas cap and remove any residual pressure from the fuel tank. Always use safety glasses while performing this operation.
Step 5: Remove the plastic safety cover from the fuel line/fuel rail connector. Push the safety clips from each side of the fuel line and gently remove the fuel line from the fuel rail. Have a shop towel ready for any high pressure residual fuel that might spray from the fuel rail.
Get pdf 2007-08 Honda Fit M/T & A/T Base Injector Upgrade Kit
