Honda CBR 600RR/1000RR Sequential LED Tail Light Installation Guide
1. Removing factory tail light. Seat removal needed (2 alien bolts and slide it outj.Upper tail needs to be removed (4 alien bolts and gently pull up and back - remove left and right side covers first). Disconnect factory tail light harness.
2. Unscrew two screws holding bracket to upper tail. Remove bracket and swap over to new LED tail light. Take note the order of the washers. Locate and disconnect the factory signal connectors (blue and orange). Remove factory signals
3. Connect the sub harness shorter end to the blue and yellow wire respectively on the tail light, insulate with green cover. Connect main 3-wire harness.
4. Connect the longer end of sub harness: Blue/Black to the Honda orange connector Yellow/Black to the Honda blue connector. Secure sub harness with cable ties, etc and reverse procedure for reinstalling the tail lamp. Test all functions before re-assembling upper tail.
Get pdf Honda CBR 600RR/1000RR Sequential LED Tail Light Installation Guide
