Blade Installation Manual
The BLADE installs easily onto round 1 7/8” to 2” diameter exhaust pipes. Important Notice: In order to install the BLADE, your car must:
• have an exposed, straight tailpipe measuring 1 7/8” - 2.0” in diameter. Example: 2004 Honda Civic
• or, dual exhaust pipes where there are 2 mufflers, each with a single exhaust pipe measuring 1 7/8” - 2.0” in diameter. Example: 2007 Lincoln Town car (in which case 2 BLADES are required).
If your car does not have either of these exhaust configurations, then your exhaust pipe will need modification. This modification is very easy to obtain at any exhaust shop i.e. Meineke, Midas, etc. Simply ask the technician to modify your tailpipe to meet this specification.
WARNING: Installing a BLADE on a tailpipe smaller than a recommended size could cause the BLADE to: (a) rattle off at the end of the tailpipe, and/or (b) not work properly.
Illustrations 1, 2, and 3 illustrate exhaust flows passing through the BLADE. The direction of the exhaust flow inside the BLADE is determined by the shape of the end of your exhaust pipe. The shapes of the exhaust pipes in Illustrations 1 and 2 are OK because they direct exhaust flows through the Exit of the BLADE. The shape of the exhaust pipe in Illustration 3 is NOT OK because it directs the exhaust flow directly into the Fabric Cartridge.
Note: Once the BLADE is properly installed on your vehicle, upon inspection you will notice that some of the exhaust flow exits the BLADE through the fabric. This is normal. The point to pay attention to is that the exhaust flow is not being aimed at , and focused directly into the fabric, as this will damage the Fabric Cartridge.
Get pdf Blade Installation Manual
