JackRabbit Honda Ridgeline Instructions
STEP 1: REMOVE PLYWOOD & INVENTORY CONTENTS
Remove the top cover from the canister box and set it aside for later installation.
Remove the canister from the box. Using the 3/8” wrench or socket remove the 2 bolts holding the plywood on the ends of the canister. Use Side Cut Pliers to cut handle retaining straps. DISCARD PLYWOOD PACKAGING AND BOLTS!
Perform a quick inventory to insure all parts are there. Be sure to check inside the small cardboard box for parts.
STEP 2: ATTACH RAIL BRACKET & RAILS TO THE CANISTER
Open the rail box along the length of the box; lift rails out to avoid scratching the rail surface on the package staples.
REMOVE PROTECTIVE PAPER ON UNDERSIDE OF RAILS. THIS IS FOR PACKAGING PURPOSES ONLY.
Find the two rear rail bracket’s and four of the #8–32 X ―” countersunk screws in the hardware kit and attach them to each of the rails at the tailgate end. (Notice that there is a Left hand side and a Right hand side bracket) (Figure 2a)
Install the rails to the canister by sliding them through the attached blanket guides on the canister, threading the blanket in the rails, and sliding the rails into the rail grips that are attached on the inside of the canister. Then slide the rails forward, towards the truck cab making sure that both of the rail grips are engaged. (Figure 2b) Complete for both left and right rails.
STEP 3: INSTALL CAB END RAIL BRACKETS & PREPARE BED
Find the two front rail brackets with rail mounting block attached to them in the hardware kit. In the truck bed remove the two factory bolts holding the front upper tie down bracket in place with a #50 torx bit. Place the front rail bracket in front (mounting block up) of the upper tie down bracket and run factory bolts back in making sure the upper tie down bracket is exactly the way it was when removed.
Get pdf JackRabbit Honda Ridgeline Instructions
